In spirit of the fans selecting the pin position at Oak Hill, I wanted to briefly explain how we move our flags on a daily basis. You may think we simply move the hole from front to middle to back and to the front again without any rhyme or reason. This myth is untrue and I plan to walk you through the setup process to give you an understanding for our daily selections.
The green we chose to highlight today was number 6 at the Players. The yellow outline illustrates the general area for today's hole. This is where our agronomic skills begin to mesh with our knowledge of the game of golf.
The hole area in the rear of number 6 is restricted due to its shape. This reduces the amount of "wiggle room" in placing a new hole. Regardless, we have a set of fundamental guidelines when selecting the day's pin location. These guidelines are based on agronomics and playability. Here are the items we consider when placing the hole.
Agronomic guidelines
- Health of the turf.
- Area with limited pitch mark scars.
- Not near old cups.
- Considerations for upcoming tournaments.
- Attempt to divert traffic patterns on a day to day basis.
Playability guidelines
- Rules of golf.
- Speed of greens.
- Flat area on the surface of the green. At least one flagstick away from severe slopes.
- Limit number of total pins tucked behind bunkers.
- MGA/LGA considerations.
- No closer than two flagsticks from the edge.
- Weather conditions, wind, moisture, etc..
- Time of year. Summer bentgrass greens hold shots. Fall and Winter the greens increase in firmness and do not hold shots.
- Incoming shots, long iron, short iron, etc..
These guidelines are simply a starter set for us to consider when setting the pin for the day. There are more complex items that we also try to address. The justification of the flags are also taken into consideration. Left, right and middle alignments are balanced whenever possible. Six of each are preferred on any given golf day.
All four courses have the Superintendent's or Assistant Superintendent's change the flags. However, some days when vital agronomic practices pull management from this duty, we try to have our most seasoned staff members plan the day's hole locations.
Now that I have briefed you on the considerations and factors in choosing a hole location, I would like to show you our process for changing the flagstick. Here are some photos detailing our pin changing procedure.
We then insert the cup into the new hole. We use the flagstick to make certain the hole is level. The flagstick and the cup are wiped clean every morning. |
We then use a cup setter to set the cup to the proper depth. We simply step on the setter to push the cup down one inch below the surface. |
The lip of the cup is then rolled level using a ten inch piece of PVC pipe. This helps to prevent the lip from "volcanoing" up. |
Here is a pick of the day's new flag. But we are not finished. Care must be taken to place the old plug. |
After placing the old plug, we water to edges to promote faster healing. |
Sand is then added to fill any voids around the edges. The green color is chosen to help blend into the green. |
A photo of the old plug. You can barely see it. |
While changing pins is an easy task in itself, it alone, may be the most important detail on the golf course everyday. Different tees are used but everyone plays to the same hole. The amount of considerations put into each day's hole position are numerous. From agronomics to golf playability there are countless items to consider. At St. James we try our best to promote healthy turf and provide a fair round of golf. Sometimes we aren't perfect, but we certainly strive to be.
No comments:
Post a Comment